|
They look great and save the cars from falling down. The cushions have five sockets that can be inserted into the prepared drill holes. Screws and sockets are included in the price. The dimensions are: 0.4 cm thick, 84.5 cm broad und 10 cm high (0.157 inches thick, 33.268 inches broad and 3.937 inches high). Available in white or transparent.
5 cm (1.97 inches) more fun: The run-out areas permit also 1:24 cars to drift in bends without colliding with other cars and can be inserted into the board just like the cushions (see above). In order to equip any combination without gaps, we have cushions and run-out areas of the length of 85, 90 and 95 cm (33.46, 35.43 and 37.4 inches).
|
Made of two parts: Below a rest supports the weight of several Slotfire modules. Above the holding devices prevent the boards from tipping over. They are made of steel sheets varnished in metallic grey. The width is equivalent to the width of the module: 85 cm (33.46 inches).
|
Each slotfire lane needs on stabilized power supply unit. If the unit is more powerful, just one will be enough as well.
|
Supports also magnetic cars. Woven of iron wire (zinc refined). Of shining silver colour. Weaving defects are seldom, very good dimensional stability. Cross-section of 5.3 x 1.3 mm (0.209 x 0.05 inches)
| |
If you can`t stand sporting, you`ll love our gripper. In any case of accident you can recover your car even from corners that are far away. The gripper is 150 cm long and as soft as a woman`s hand.
We do deliver controllers from Parma, NSR and Tigre and also race cars suitable for wooden race tracks.
| 
